Concrete cutting
Cut concrete faster without beating up the saw.
Cement-based material grinds down diamond tooling and drags on the motor. C Complex lowers resistance at the cutting surface so production speeds up and the equipment works less.
What changes when you add it to your water
- Grinding and cutting rate up to 3x faster.
- Diamond tooling lasts up to 40% longer.
- Resistance at the cutting surface drops; the machine works less.
- Built-in rust and corrosion inhibitors protect the equipment.
- Cuts run smoother with less vibration.
Proof
Airport runway cut, 2021. A road saw dosed at 1% C Complex cut 118 linear meters at 430 mm depth in 57 minutes. The contractor said the same cut normally took two to three hours on that site. Slurry stayed close to the cut and vacuumed up easily, with minimal blade wear.
Your stack
Four products, one loop: the additive goes in, the water gets recycled, the slurry gets handled, and the buildup comes off.
C Complex
The concrete-cutting additive. Goes in the water line ahead of the saw.
Dosatron
Water-powered dosing. Right concentration every cut, no electricity.
AquaTerra Maxx
Clears process water and drops a dense, dewaterable sludge.
Dewatering bags
Separate water from concrete slurry for easier disposal.
Dose at 1:100. Stay at 1% or under in recirculating systems to avoid foaming.
The First Cut Test, on your floor
One saw or one job, two weeks. We set the dosing rate with you by phone. Log production speed and tooling wear before and after. The test costs you nothing but an hour.